User's Manual

Preface
iii
responsible for testing their end-product for any additional
compliance requirements required with this module installed
(for example, LVD TV… etc.).
IMPORTANT NOTE: In the event that these conditions can
not be met (for example certain laptop configurations or co-
location with another transmitter), then the FCC authoriza-
tion is no longer considered valid and the FCC ID can not be
used on the final product. In these circumstances, the OEM
integrator will be responsible for re-evaluating the end prod-
uct (including the transmitter) and obtaining a separate FCC
authorization.
End Product Labeling
This transmitter module is authorized only for use in device
where the antenna may be installed such that 20 cm may be
maintained between the antenna and users. The final end
product must be labeled in a visible area with the following:
“Contains FCC ID: N89-WM821M”.
Manual Information To the End User
The OEM integrator has to be aware not to provide
information to the end user regarding how to install
or remove this RF module in the user’s manual of
the end product which integrates this module.
The end user manual shall include all required regulatory in-
formation/warning as show in this manual.