CyberTAN Product Specification WM140 2.4GHz Draft 802.
1. Specification Specifications Product Name Network Standards Data Rate Modulation Technique Network Architecture Operating Frequency Operating Channels 802.11 b/g/n Wireless LAN Module Draft IEEE802.11n and 11 b/g -compliant 802.11b: 11 / 5.5 / 2 / 1Mbps 802.11g: 54 / 48 / 36 / 24 / 18 / 12 / 9 / 6Mbps Draft 802.11n (20MHz, 800ns GI): 65, 58.5, 52, 39, 26, 19.5, 13, and 6.5Mbps Draft 802.11n (40MHz, 400ns GI): 135, 121.5, 108, 81, 54, 40.5, 27, and 13.5Mbps 802.11g/n---- OFDM 802.
Receive Sensitivity -84 dBm @ 11M (CCK, 10% PER) -70 dBm @ 54M (2RX 11g OFDM, 10% PER) -70 dBm @ 54M (2RX 11a OFDM, 10% PER) -6 4 dBm @ 130Mbps (2.4GHz, 2RX 11n OFDM with 20MHz BW, 10% PER) -62 dBm @ 270Mbps (2.4GHz, 2RX 11n OFDM with 40MHz BW, 10% PER) Operating Temperature Humidity TX Power consumption: < 700 mA RX Power consumption: < 460 mA 0 to 60 ℃ 20% to 95% Non-condensing Voltage 3.3V Power Consumption 2. Drivers Release Plan Windows 2000 Windows XP Linux VxWorks Driver Release time 3.
. W arranty One year limited warranty. 4.1 Warning statement Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of th e F CC Rule s. These limits are designed to provide re asonable pro tection against ha rmful inte rference in a residential inst allation.
This device is intended only for OEM integrators under the following conditions: 1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and 2) The transmitter module may not be co-located with any other transmitter or antenna, 3) For all products market in US, OEM has to limit the operation channels in CH1 to CH11 for 2.4G band by supplied firmware programming tool. OEM shall not supply any tool or info to the end-user regarding to Regulatory Domain change.
IMPORTANT NOTE: IC Radiation Exposure Statement: This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. This device is intended only for OEM integrators under the following conditions: The transmitter module may not be co-located with any other transmitter or antenna. As long as conduction above is met, further transmitter test will not be required.
