User's Manual

default IP address of 192.168.1.1

Finally, use the Ping command in MS-DOS mode to verify the network

connection:

Ping 127.0.0.1 to check the TCP/IP stack of your computer

Ping gateway IP (Default: 192.168.1.1) to check the internal link of

network.

Note if you’re not able to view the web configuration screen for the 11g Wireless Broadband

router , make sure that you remove any proxy setting within your Internet browser, or remove

the dial-up settings within your browser.

Q: What can I do if I have forgotten the password for the 11g Wireless Broadband

router ?

You have to reset the Wireless Broadband router back to the factory default setting by pushing

the Reset button for longer than 3 seconds. Refer to the user’s manual to re-configure the

settings.

Q: I cannot access my ISP’s home page, why?

Some ISPs, such as @Home, require that their host name be specifically configured into your

computer before you can surf their local web pages. If you are unable to access your ISP’s

home page, enter your ISP’s Domain Name into the OnePage Setup (3-3) to enable all

computers in your LAN access to it. If you only want to allow computers to access these home

pages, open the TCP/IP Properties window (2-4) on these computers, click the “DNS

Configuration” tab and enter your ISP’s Domain Name in the “Domain Name Search Suffix”

location.

Client Side (Computers)

Q: I can’t browse in the Internet via the 11g Wireless Broadband router

A: Check the following:

 Check that the LAN Link/ACT LED on the front panel is lit to indicate proper connection

between the computer and the 11g Wireless Broadband router .

 Check if both ends of the network cable are properly connected.

 Check that TCP/IP is installed on your computer (2-4).

For Windows 95/98, use a MS-Dos prompt to run “winipcfg” (“Ipconfig” for Windows NT).

Check that the computer’s IP Address is within the range of 192.168.1.2 ~ 192.168.1.254 and

the Subnet Mask is 255.255.255.0. If you are using a fixed IP address, also check the Default

Gateway IP Address and DNS address in “More”.

 Check that the values as stated above are the same in Status Monitor (4-7).

Q: I get a time out error when I enter a URL or IP address.

A: Check whether other computers work. If they do, ensure the computer’s IP settings are

correct (IP Address, Subnet Mask, Gateway IP Address and DNS) (3-3). Then check whether

the 11g Wireless Broadband router ’s settings are correct (3-3).