User's Manual

62
Source IP:
You can chose to issue the ping test from the LAN side
by selecting Router’s private IP Address or from the
WAN side by selecting Router’s WAN IP Address.
Destination IP:
Enter the IP Address of destination device you want to
ping. If Router’s LAN IP address is selected as Source
IP, you only can ping LAN side device and vice versa.
Packet Number:
Enter the packet numbers you wish to use to ping the
destination device. The maximum numbers are four.
Packet Size:
Enter the numbers of packet size you wish to use to
ping the destination device. The maximum packet sizes
are 1514.
Time Between
Enter the numbers of time between two packets.
Time out:
Enter the number of time regarding as no response
after starting to ping the destination device.
Start:
Click this button to begin the ping test.
Ping Result:
The result will show the numbers of sending packet,
numbers of packet receiving, and the average return
time.
Tracert
Tracert Host:
Enter the IP Address of destination device that you
wish to trace the route between Router and that device.
Trace Message:
The result shows the routing information between
Rddiidi