User's Manual

57
through the Wireless Broadband router if there is LAN
PC using IPSec for data communication with other
Internet device.
PPTP Pass Through:
Check the Enable to allow the PPTP packets to pass
through the Wireless Broadband router if there is LAN
PC using PPTP for data communication with other
Internet device.
PPPoE Pass Through:
Check the Enable to allow the PPPoE packets to pass
through the Wireless Broadband router if there is LAN
PC using PPPoE for data communication with other
Internet device.
Remote Upgrade:
Check Enable if you want to allow the authorized
remote users to upgrade firmware from WAN side.
Reset Device:
Select “Yes” if you want to clear a connection, reboot,
and re-initialize the unit without affecting any of your
configuration setting.
Factory Defaults:
Select “Yes” if you want to return all the router’s
current settings to their factory defaults. Note that do
not restore the factory defaults unless it is absolutely
necessary.
Apply
Click this button after making any changes for
activating the settings.
Cancel
Click this button if you are not satisfied with the
settings in this page before clicking Apply.
5-2 Status Monitor
This screen shows the router’s current status. All of the information provided is read-only.