User's Manual

46
“RX” (receive) function.
Show Routing Table:
Click this button after clicking Apply to see current
routing information.
Apply:
Click this button after making any changes for
activating the settings.
Undo:
Click this button if you are not satisfied with the
settings in this page before clicking Apply.
Below is Routing Table Entry List. This table shows the status for routing information. You can
click Refresh to update the table information.
4-6 Static Routing
The Static Routing feature allows PCs that are connected to the Wireless Broadband router,
either directly or through a hub/switch (in the immediate LAN), to communicate with other PCs
in the respective LAN segment which are connected to the Wireless Broadband router through
another router (destination LAN). Up to 20 route entries may be input into the Wireless
Broadband router. The diagram below gives an example of the physical connections required to
use Static Routing.
In the above diagram, PC2 in LAN#2 is connected to the Wireless Broadband router via another
router while PC1 in LAN#1 is connected to the Wireless Broadband router directly. Without
configuring the Static Routing function, the two PCs would not be able to communicate with
each other.