User's Manual

43
IP Address” is set to the Router’s default setting of
192.168.1.1. If a fixed Public IP Address is to be used,
select “Specify an IP address” and enter the IP
Address and other necessary information provided by
your ISP.
UPnP Control:
Check “Enable” will allow LAN side PCs that support
UPnP to directly configure the settings provided in this
page.
Application Name
UPnP has ten pre-setting forwarding rules, which are
well-known applications. You can enter any name to
present the additional settings beside those pre-setting
rules.
Ext. Port
Most of applications usually use their individual port
number for its incoming and outgoing data packets.
However, some of the application may use different
port number for incoming and outgoing data packets.
In this case, you have to enter the port number used by
incoming data packets here.
Protocol
Specify the protocol type as “TCP” or “UDP” which
is used by specific service.
Int. Ports
Most of applications usually use their individual port
number for its incoming and outgoing data packets.
However, some of the application may use different
port number for incoming and outgoing data packets.
In this case, you have to enter the port number used by
outgoing data packets here.
IP Address
Enter the appropriate IP Addresses of the service
computers in the “IP Address” locations.
Enable
Check to make this forwarding setting active.
Apply
Click this button after making any changes for
activating the settings.
Cancel
Click this button if you are not satisfied with the
settings in this page before clicking Apply.
Example: If the service port number 80~80 (representing an HTTP web address)