User's Manual

40
Set up individual network computers to act as servers and configure each with a
fixed IP Address.
Note: In the “One Page Setup” screen, ensure the “Private IP Address” is set
to the Wireless Broadband router’s default setting of 192.168.1.1. If a fixed
Public IP Address is to be used, select “Specify an IP address” and enter the
IP Address and other necessary information provided by your ISP.
Ports:
Enter the desired service port numbers in the “Ports”
fields. You can specify the protocol type as “TCP” or
“UDP” from the drop-down list. If you are not sure
which one to select, choose “Both”. A selection of
well-known service port numbers is provided on this
screen.
Redirect IP Address:
Enter the appropriate IP Addresses of the service
computers in the “Redirect IP Address” locations.
Passive FTP Virtual
Server:
When there is firewall filtering in your network, the
Internet user may not be able to access FTP server you
set in the LAN side. Setting FTP server at passive
mode will be necessary.
Enable/Disable - Click to enable/disable passive FTP