User's Manual

30
ISPs use this protocol as way to establish the initial connection between the
CPE (end-user side) and DSLAM (ISP side). If your ISP uses PPTP to establish
the connection, you should select this item and follow the steps below.
Specify WAN IP Address:
Enter the IP address provided by your ISP. If your
ISP provides you an Alcatel Speed Touch
TM
modem, it is suggested that you enter 10.0.0.150
in this column.
Subnet Mask:
Enter the subnet mask values provided by your
ISP.
Default Gateway IP
Address:
Your ISP will provide you with the Default
Gateway IP Address. If your ISP provides you an
Alcatel Speed Touch
TM
modem, it is suggested
that you enter the 10.0.0.138 in this column.
User Name:
Enter the user name provided by your ISP.
Password:
Enter the password provided by your ISP.
Connect-on-demand:
It is a utility used to trigger the PPTP session
when there is packet being sent through the WAN
port while it is on disconnected situation. Check
the radio button to make this function active, and
then you must enter the number of minutes you
wish the network to remain idle before
disconnection occurs in the “Max Idle Time”
location.
Keep Alive:
This function keeps your PPTP connection enable
even if it remains idle. However, in some