User's Manual

27
User Name:
Enter the user name your ISP provides you.
Password:
Enter the password your ISP provides you.
Connect-on-demand:
It is a utility used to trigger the PPPoE session
when there is a packet being sent through the
WAN port while it is on disconnected situation.
Check the radio button to make this function
active, and then you must enter the number of
minutes you wish the network to remain idle
before disconnection occurs in the “Max Idle
Time” location.
Service Name
Fill in this if it’s required by your ISP
Keep Alive:
This function keeps your PPPoE connection
enable even if it remains idle. However, in some
situation, PPPoE session cannot be established
immediately after disconnection. This is because
the system on the ISP’s site may need a little time
to restore itself. You may need to check with your
ISP to obtain detail of how long you need to wait
before re-establish the PPPoE session. Enter this