User's Manual

1
FCC Interference Statement
This device complies with Part 15 of FCC rule. Operation is subject to the following two
conditions:
 This device may not cause harmful interference.
 This device must accept any interference received, including interference that may
cause undesired operation.
This 11g Wireless Broadband Router has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
according to the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
1.This equipment should be installed and operated with minimum distance 20cm between the radiator and
your body.
2.This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
3.Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user authority to operate the equipment.
If this equipment does cause harmful interference to radio or television reception, which is
found by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment or device.
 Connect the equipment to an outlet other than the receiver’s.
 Consult a dealer or an experienced radio/TV technician for assistance.
CE Declaration of Conformity
This equipment complies with the specifications relating to electromagnetic compatibility, EN
55022/A1 Class B, and EN 50082-1. This meets the reasonable protection requirements set out
in the European Council Directive on the approximation of the laws of the member states
relating to Electromagnetic Compatibility Directive (89/336/EEC).
Manufacturer’s Disclaimer State
The information in this document is subject to change without notice and does not represent a
commitment on the part of vendor. No warranty or representation, either expressed or implied,
is made with respect to the quality, accuracy or fitness for any particular prupose of this
document. The manufacturer reserves the right to make change to the content of this document
and/or the products associated with it at any time without obligation to notify any person or
organization. In no event will the manufacturer be liable for direct, indirect, special, incidental