User's Manual

12
Chapter 2: Installation
This chapter provides information about your 11g Wireless Broadband Router’s
physical features and gives step-by-step installation instructions for hardware
installation and software configuration.
Front Panel
The following figure shows the front view of the 11g Wireless Broadband
Router. The LEDs on the front panel indicate the status of the unit. You can
easily view the operation of your 11g Wireless Broadband Router from this
panel.
Note: Please refer to the model on your hand to find proper description.
LED Status Description
Power: Green Steady on when the power is on.
Diag: Red Lights up during system checking connections and
internal operation when the power is first switched
on. If the device works properly, the light should
switch off automatically.
WLAN
Link/Act:
Green  Steady on when the wireless AP is enabled.
When the wireless AP is disabled (through the
web-based utility), the LED should remain off.
 Blinking when data is flowing through Wireless
AP.
WAN
Link/Act:
Green  Steady on when the Ethernet link exists.
 Blinking when data is flowing through this port.