User's Manual
Table Of Contents
- WD® Service and Support
- Important User Information
- Product Overview
- Getting Started
- Configuring Basic Settings
- Configuring Advanced Settings
- Setting up the Bridge in AP Mode
- Troubleshooting DO THESE APPLY?
- Regulatory and Warranty Information
- Appendix: Technical Specifications
- Index
CONFIGURING BASIC SETTINGS
18
MY NET AC WI-FI BRIDGE
USER MANUAL
3. Click Save.
Connection Type Can be Static IP, Dynamic IP (DHCP), PPPoE
(Username/Password), or PPTP (Username/
Password).
If you select Static IP, the following additional fields display:
IP address (should be capital A)–IP address of the bridge. It
should be on the same network as your router.
Subnet–The subnet mask is used to control how many
subnetworks can exist in your local network. The more
subnetworks there are, the fewer the hosts you can have per
subnet.
Gateway–IP address of the router to which this bridge is
connected.
Status Status can be Unconfigured, Configured and Connected, or
Unconnected.
Number of Devices
Connected
Number of devices connected to the bridge. Wirelessly only or
via USB port too?
QoS Enabled
Enable or disable the Fastrak (or WMM?) QoS application,
which prioritizes different client applications/traffic types over the
Internet. Enabled by default.
Setting Description