User's Manual
Table Of Contents
- WD® Service and Support
- Important User Information
- Product Overview
- Getting Started
- Configuring Basic Settings
- Configuring Advanced Settings
- Setting up the Bridge in AP Mode
- Troubleshooting DO THESE APPLY?
- Regulatory and Warranty Information
- Appendix: Technical Specifications
- Index
3
GETTING STARTED
8
MY NET AC WI-FI BRIDGE
USER MANUAL
Getting Started
This chapter contains the following topics:
Setting up the Bridge with a WPS-Enabled Router
Set
ting up Your bridge Manually
Setting up the Bridge with a WPS-Enabled Router
You have two options for setting up the bridge. If your router is WPS enabled, follow steps 1
and 2 below. If your router is not WPS enabled or you are experiencing interference
problems, go to “Setting up Your bridge Manually” on page 10.
Step 1: Connect the bridge to Your Router
1. Connect the bridge to a power source and press the Power button.
2. Press the Wi-Fi Protected Setup button (sometimes labeled WPS) on your router and
the WPS button on the bridge within two minutes.
Note: If your router does not support WPS, see “Setting up Your bridge
Manually” on page 10.
The Connection light is blue when the router and the bridge are connected.
1