User's Manual
Table Of Contents
- WD® Service and Support
- Important User Information
- Product Overview
- Getting Started
- Configuring Basic Settings
- Configuring Advanced Settings
- Setting up the Bridge in AP Mode
- Troubleshooting DO THESE APPLY?
- Regulatory and Warranty Information
- Appendix: Technical Specifications
- Index
PRODUCT OVERVIEW
6
MY NET AC WI-FI BRIDGE
USER MANUAL
Front LED indicators
Side Panel
Side components
LED Description
Power Steady when the bridge is powered on and operational; flashes
slowly during
boot-up, firmware upgrades, and system self-tests.
Wireless Lit when wireless connection is active.
Wi-Fi Protected
Setup (WPS)
When connecting the bridge and a wireless device (e.g., a printer)
that you want to add to the network, the LED indicates the status of
WPS:
• When WPS is connecting a network device, the light blinks slowly.
• If an error occurs during setup, the light blinks quickly.
• After setup, light is solid when WPS is active.
Button Description
Power button Use the included AC power adapter to connect this port to the
power source.
WPS (Wi-Fi
Protected
Setup) button
Enables you to configure Wi-Fi security on WPS-enabled devices.
Ethernet (LAN)
or Internet ports
Use an Ethernet (network) cable to connect wired network devices
to these ports.
Power port Use the included AC power adapter to connect this port to the power
source.