User's Manual
Table Of Contents
- WD® Service and Support
- Important User Information
- Product Overview
- Getting Started
- Configuring Basic Settings
- Configuring Advanced Settings
- Setting up the Extender in AP Mode
- Troubleshooting
- Regulatory and Warranty Information
- Appendix: Technical Specifications
- Index
3
GETTING STARTED
8
MY NET WI-FI EXTENDER
USER MANUAL
Getting Started
This chapter contains the following topics:
Setting up the Extender with a WPS Enabled Router
Sett
ing up Your Extender Manually
Setting up the Extender with a WPS Enabled Router
If your router is WPS enabled, follow the steps below. If your router is not WPS enabled or
you are experiencing interference problems, go to “Setting up Your Extender Manually” on
page 9.
1. Set the frequency switch to the frequency of the router (2.4 GHz or 5.0 GHz).
Note: If you don’t know whether your router is dual-band, leave the switch set to
2.4 GHz.
2. Connect the extender to a power source and press the Power button.
3. If WPS is enabled on your router, press the Wi-Fi Protected Setup button (sometimes
labeled WPS) on your router and within two minutes, press the WPS button on the
extender.
Note: If your router does not support WPS, see “Setting up Your Extender
Manually” on page 9.
The wireless connection light is blue when the extender’s wireless connection is active.
1