User's Manual
Table Of Contents
- WD® Service and Support
- Important User Information
- Product Overview
- Getting Started
- Configuring Basic Settings
- Configuring Advanced Settings
- Setting up the Extender in AP Mode
- Troubleshooting
- Regulatory and Warranty Information
- Appendix: Technical Specifications
- Index
PRODUCT OVERVIEW
7
MY NET WI-FI EXTENDER
USER MANUAL
Side components
Port LED indicators
Back (not shown)
Button Description
Power button Use the included AC power adapter to connect this port to the
power source.
WPS (Wi-Fi
Protected
Setup) button
Enables you to configure Wi-Fi security on WPS-enabled devices.
Frequency
switch
Switch to configure the extender to connect at either
2.4 GHz or 5.0 GHz frequency band.
Ethernet (LAN)
or Internet port
Use an Ethernet (network) cable to connect wired network devices
to these ports.
or
Use an Ethernet (network) cable to connect this port to a modem.
Power port Use the included AC power adapter to connect this port to the power
source.
Component LED Description
Ethernet port Link LED (Green) Steady on when a cable connects the port to
another Ethernet port.
Activity LED (Yellow) Blinks to indicate network activity of that
Ethernet port.
Internet port Link LED (Green) On when a cable connects the port to the
modem.
Activity LED (Yellow) Blinks to indicate network activity on that port.
Component Description
Reset button Press and release–Reboots the extender. When the reset finishes, the Power
LED blinks.
Press and hold for 5 seconds or longer–Resets to factory default settings.