Manual

Table for Filed Antenna
Ant. Brand Part No. Antenna Type Connector Gain (dBi) Loss of
Cable (dB)
True Gain
(dBi)
1 TONGDA T-543-2020003-2 Dipole Reversed SMA 5.00 0.70 4.30
2 TONGDA T-543-2020003-2 Dipole Reversed SMA 5.00 0.70 4.30
- - Printed N/A 4.32 - 4.32
Note: The EUT has three antennas (2TX, 2RX).
This module is intended for OEM integrator. The OEM integrator is still responsible for the IC
compliance requirement of the end product, which integrates this module.
Any changes or modifications not expressly approved by the manufacturer could void the user's
authority to operate this equipment.
USERS MANUAL OF THE END PRODUCT:
In the users manual of the end product, the end user has to be informed to keep at least 20cm
separation with the antenna while this end product is installed and operated. The end user has to be
informed that the IC radio-frequency exposure guidelines for an uncontrolled environment can be
satisfied. The end user has to also be informed that any changes or modifications not expressly
approved by the manufacturer could void the user's authority to operate this equipment. Operation is
subject to the following two conditions: (1) this device may not cause harmful interference and (2) this
device must accept any interference received, including interference that may cause undesired
operation.
LABEL OF THE END PRODUCT:
The final end product must be labeled in a visible area with the following " Contains IC: 5005A-WD114
".
The Host Model Number (HMN) must be indicated at any location on the exterior of the end product or
product packaging or product literature which shall be available with the end product or online.