User's Manual
Table Of Contents
- Before You Begin
- Cisco WAP371 Wireless-AC/N Dual Radio Access Point with Single Point Setup Features
- Mounting the Cisco WAP371 Wireless-AC/N Dual Radio Access Point with Single Point Setup
- Connecting the Cisco WAP371 Wireless-AC/N Dual Radio Access Point with Single Point Setup
- Verifying the Hardware Installation
- Getting Started with the Configuration
- Suggested Next Steps
- Rebooting the Devices or Returning them to their Factory Default Settings
- Where to Go From Here
- Avant de commencer
- Caractéristiques du point d'accès bibande sans fil AC/N Cisco WAP371 avec configuration de point unique
- Montage du point d'accès bibande sans fil AC/N Cisco WAP371 avec configuration de point unique
- Connexion du point d'accès bibande sans fil AC/N Cisco WAP37 avec configuration de point unique
- Vérification de l'installation matérielle
- Configuration
- Étapes supplémentaires recommandées
- Redémarrage des appareils ou restauration des paramètres par défaut
- Pour en savoir plus
- 使用准备
- 具有单点设置功能的 Cisco WAP371 Wireless- AC/N 双频接入点
- 具有单点设置功能的 Cisco WAP371 Wireless- AC/N 双频接入点的安装
- 具有单点设置功能的 Cisco WAP371 Wireless- AC/N 双频接入点的连接
- 验证硬件安装
- 配置入门
- 建议的后续步骤
- 重启设备或恢复出厂默认设置
- 快速索引
FCC Statement:
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and receiver.
● Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
● Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation.
For product available in the USA/Canada market, only channel 1~11 can be operated. Selection of other channels is not possible.
This device and it's antennas(s) must not be co-located or operating in conjunction with any other antenna or transmitter except in
accordance with FCC multi-transmitter product procedures.
This device is going to be operated in 5.15~5.25GHz frequency range, it is restricted in indoor environment only.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be
installed and operated with minimum distance 20cm between the radiator & your body.
Devices will not permit operations on channels 120-132 for 11a and 11n/a which overlap the 5600 - 5650 MHz band.