User's Manual
Table Of Contents
- Before You Begin
- Cisco WAP371 Wireless-AC/N Dual Radio Access Point with Single Point Setup Features
- Mounting the Cisco WAP371 Wireless-AC/N Dual Radio Access Point with Single Point Setup
- Connecting the Cisco WAP371 Wireless-AC/N Dual Radio Access Point with Single Point Setup
- Verifying the Hardware Installation
- Getting Started with the Configuration
- Suggested Next Steps
- Rebooting the Devices or Returning them to their Factory Default Settings
- Where to Go From Here
- Avant de commencer
- Caractéristiques du point d'accès bibande sans fil AC/N Cisco WAP371 avec configuration de point unique
- Montage du point d'accès bibande sans fil AC/N Cisco WAP371 avec configuration de point unique
- Connexion du point d'accès bibande sans fil AC/N Cisco WAP37 avec configuration de point unique
- Vérification de l'installation matérielle
- Configuration
- Étapes supplémentaires recommandées
- Redémarrage des appareils ou restauration des paramètres par défaut
- Pour en savoir plus
- 使用准备
- 具有单点设置功能的 Cisco WAP371 Wireless- AC/N 双频接入点
- 具有单点设置功能的 Cisco WAP371 Wireless- AC/N 双频接入点的安装
- 具有单点设置功能的 Cisco WAP371 Wireless- AC/N 双频接入点的连接
- 验证硬件安装
- 配置入门
- 建议的后续步骤
- 重启设备或恢复出厂默认设置
- 快速索引
Cisco Small Business WAP371 Series Wireless Access Point 3
A Kensington lock slot is found under the lights.
Back Panel
The back panel of the device has an RJ-45 Ethernet port. Use the Ethernet port to
power your device using PoE. It is an auto-sensing, Gigabit Ethernet (802.3) port
used to connect your WAP devices to network devices, such as computers, routers, or
switches. We strongly recommend that you use a Category 5e or better cable for
gigabit connectivity.
The back panel of the device has a Reset button. See “Rebooting the Devices or
Returning them to their Factory Default Settings” for information on the Reset button.
Default Settings
If you are using a Cisco Small Business RV Series router, the default range for the
DHCP assigned address is from 192.168.1.100 to 192.168.1.254. Any device
connecting to the same LAN will be assigned an IP address in this range.
Parameter Default Value
Username cisco
Password cisco
LAN IP Address DHCP address assigned by
server
Fallback LAN IP 192.168.1.245
Subnetwork Mask 255.255.255.0