User's Manual

2.4G 54Mbps Wireless AP User's Manual
6
2.Hardware Installation
Physical Details
Rear Panel
Reset Button “Reset” mean “ Initiation”. While pressing the button, the Ethernet
Bridge will reboot and reset current configurations to factory default
settings. The left indicator “ DIAG” on Ethernet Bridge will be off
and then begin blinking. Then this initiation action will be
completed when the indicator “ DIAG” is always green instead of
blinking.
LAN Cable
Selection “Auto MDIX”, no mater that plug-in the RJ-45 port Tx and Rx lines
are reversed or normal, it will auto select the proper mode to
connect to PC or Hub/Switch.
Power Input Use Only the power Ethernet Bridge supplied with the Ethernet Bridge
LAN Connection Use standard Ethernet cable (RJ-45 connector) to connect your
PC, hub/switch or broadband router/modem to this LAN port.
LAN Connection
Power Input
Reset
Button
Antenna
Connector