User's Manual

11Mbps Wireless Ethernet Adapter User's Manual
23
The Server Tab
IP Address Mode: Select “Static” or
“DHCP” mode. For “Static” mode,
the IP address settings are given by
user. For “DHCP” mode, IP settings
will be overridden by a DHCP server
on your network. The default setting
is “Static”
IP Address: The static IP address
you may assign to the adapter. The
default value is “192.168.1.200
”.
Subnet Mask: The subnet mask you
want to assign for the adapter. The
default value is “255.255.255.0
”.
Gateway: The gateway you want to
assign for the adapter. The default
value is “192.168.1.1
”.
Device Name: optional device name
setting
Allow upgrade : Check the box, and
then it is allowed to upgrade
firmware.
Cloning Bridge
Note!
You may need to reboot the adapter, and then re-load the page to see
any new settings.
The Stations Tab
The bridge table: display the stations
IP address and Mac address