User Manual

8
The Gigaset SE587 WLAN dsl
Reset Button
Reboot function (software reset): Press the button for longer than 1 second but less
than 5 seconds to reboot the device. This does not affect the configuration settings.
Reset function (returns to factory settings): Press and hold the button for at least
5 seconds to return all settings to the factory settings.
Warning: This will clear all the configuration settings you have made since the initial
startup. Do not perform this action without first consulting the hotline of your Internet
service provider.
LED displays
The upper side of the device has LED displays that show the operating state and simplify
installation and troubleshooting in the network.
The LEDs show the following:
LED State Status
Power
On (green)
The device is powered on and has been booted success-
fully.
Flashing
(green)
System is booting.
Off The device is powered off.
On (red)
The device cannot be booted or a malfunction has been
detected.
LAN1 –
LAN4
On
A device is connected to the relevant LAN port and a
connection has been established.
Flashing The LAN port is transmitting or receiving data (traffic).
Off
There is no device connected or the connected device is
powered off.
WLAN
On
The wireless interface is activated, no data transmission
at present.
Flashing
The device is transmitting or receiving data on the wire-
less interface.
Off The wireless interface is deactivated.
ADSL
On
The device is connected to the ADSL port of the splitter
and the ADSL connection has been synchronised suc-
cessfully.
Flashing The ADSL connection is being synchronised.
Off
There is no connection to the ADSL port of the splitter or
the ADSL connection cannot be synchronised.