User's Manual
Table Of Contents
- Federal Communication Commission Interference Statement
- Getting Started
- Using the Setup Wizard
- Viewing System Status
- Port Management
- Networking
- VPN
- Quality of Service (QoS)
- Security
- System Management
- Where to Go From Here
System Management
Configuring TR-069
Cisco RV315W Broadband Wireless VPN Router Administration Guide 93
9
STEP 3 In the Set System Time area, select the Dynamically radio button to automatically
synchronize the date and time with the specified NTP servers:
• NTP Server 1: Enter the IP address or domain name of the primary NTP
server.
• NTP Server 2: Enter the IP address or domain name of the secondary NTP
server.
STEP 4 Click OK to save your settings.
Configuring TR-069
TR-069 is a DSL Forum specification for CPE WAN Management Protocol (CWMP).
It defines an application layer protocol for remote management of end-user
devices. As a bidirectional SOAP/HTTP-based protocol, it provides the
communication between customer-premises equipment (CPE) and Auto
Configuration Servers (ACS).
Configuring TR-069 Settings
To configure general TR-069 properties:
STEP 1 Click System Management > TR-069 Settings > TR-069 Settings. The TR-069
Settings page opens.
STEP 2 Enter the following information:
• TR-069: Click Enable to enable the TR-069 server, or click Disable to
disable it.
• ACS: Specify the following settings of the ACS remote management server:
- URL: Enter the URL of the ACS remote management server.
- Username: Enter the username to log in to the ACS remote management
server.
- Password: Enter the password to log in to the ACS remote management
server.
• CPE: Specify the CPE settings for TR-069 remote management: