User's Manual

Networking
Configuring Routing
Cisco RV315W Broadband Wireless VPN Router Administration Guide 64
5
• RIP Time: Enter the values for the RIP refresh time, RIP timeout, and Flush
time.
• RIP Settings: Select an interface or a RIP network for routing.
STEP 3 In the RIP Members area, if RIPv2 is enabled, you can check RIP Enabled to
enable the RIP settings on the port. To specify the RIP settings for each available
interface, click the Edit icon.
STEP 4 Enter the following information:
• RIP: Displays whether RIP is enabled or disabled on this interface.
• Port Passive: Determines how the RV315W receives RIP packets. Check
Enable to enable this feature on the port.
• Authentication: Specify the authentication method for the port.
- None: Choose this option to invalidate the authentication.
- Simple Password Authentication: Choose this option to validate the
simple password authentication. Enter the password in the field.
- MD5 Authentication: Choose this option to validate the MD5
authentication.
STEP 5 In the RIP Networks area, you can manually add RIP networks. To add a new RIP
network, click Add.
STEP 6 Click OK to save your settings.
STEP 7 To edit the settings of a RIP network, select the corresponding entry and click the
Edit icon. To delete a RIP network, select the corresponding entry and click the
Delete icon.
Viewing the Routing Table
To open the Routing Table page, click Networking > Routing > Routing Table. The
following information is displayed:
• Destination Address: The IP address of the host or the network that the
route leads to.
• Subnetwork Mask: The subnet mask of the destination network.
• Gateway: The IP address of the gateway through which the destination
host or network can be reached.