User's Manual
Table Of Contents
- Federal Communication Commission Interference Statement
- Getting Started
- Using the Setup Wizard
- Viewing System Status
- Port Management
- Networking
- VPN
- Quality of Service (QoS)
- Security
- System Management
- Where to Go From Here
Networking
Configuring DMZ
Cisco RV315W Broadband Wireless VPN Router Administration Guide 58
5
icon. To delete multiple port triggering rules at a time, select the corresponding
rules and click the Delete button.
Configuring DMZ
This section describes how to configure the software DMZ and hardware DMZ
features.
Configuring Software DMZ
To configure software DMZ:
STEP 1 Click Networking > DMZ > Software DMZ. The Software DMZ page opens.
STEP 2 To create a DMZ rule, enter the following information:
• DMZ Status: Check Enable to enable this DMZ rule, or check Disable to
disable this DMZ rule.
• External IP: Enter the external IP address.
• Internal IP: Enter the IP address of the internal server in the DMZ network.
• Binding Interface: Select the interface for this DMZ rule.
STEP 3 Click OK to save your settings.
STEP 4 To edit a software DMZ rule, select the corresponding rule and click the Edit icon.
To delete a software DMZ rule, select the corresponding rule and click the Delete
icon.