User's Manual

Configuring Networking
Configuring Port Management
Cisco RV 120W Administration Guide 52
2
•
MD5 Key ID
—Input the unique MD-5 key ID used to create the
Authentication Data for this RIP v2 message.
•
MD5 Auth Key
—Input the auth key for this MD5 key, the auth key that is
encrypted and sent along with the RIP-V2 message.
•
Not Valid Before
—Enter the start date when the auth key is valid for
authentication.
•
Not Valid After
—Enter the end date when the auth key is valid for
authentication.
STEP 5 Click S
Save
.
Configuring Port Management
The Cisco RV 120W has four LAN ports. You can enable or disable ports, configure
if the port is half- or full-duplex, and set the port speed.
To configure LAN ports:
STEP 1 Choose N
Networking
> P
Port Management
.
STEP 2 To enable a port, check the
Enable
box. To disable the port, uncheck the E
Enable
box. By default, all ports are enabled.
STEP 3 Check the A
Auto
box to let the router and network determine the optimal port
settings. By default, automatic mode is enabled. This setting is available only when
the E
Enable
box is checked.
STEP 4 (Optional) Choose either half- or full-duplex based on the port support. The default
is full-duplex for all ports. This setting is available only when the A
Auto
check box is
unchecked.
STEP 5 (Optional) Select one of the following port speeds: 1
10 Mbps
or 1
100 Mbps
. The
default setting is 100 Mbps for all ports. This setting is available only when the
Auto
check box is unchecked. You can change the port speed if a network is
designed to run at a particular speed, such as 10 Mbps mode. In this case, the
endpoint also uses 10 Mbps mode either by auto-negotiation or manual setting.
STEP 6 Click S
Save
.