User's Manual

Introduction
Viewing Device Statistics
Cisco RV 110W Administration Guide 26
1
•
Multicast
—The number of multicast packets sent over this radio.
•
Collisions
—The number of packet collisions reported to the AP.
AP Statistics
This table displays transmit/receive data for a given AP.
•
AP Name
—The name of the AP.
•
Packets
—The number of transmitted/received (tx/rx) wireless packets on
the AP.
•
Bytes
—The number of transmitted/received (tx/rx) bytes of information on
the AP.
•
Errors
—The number of transmitted/received (tx/rx) packet errors reported
to the AP.
•
Dropped
—The number of transmitted/received (tx/rx) packets dropped by
the AP.
•
Multicast
—The number of multicast packets sent over this AP.
•
Collisions
—The number of packet collisions reported to the AP.
•
Poll Interval
—Enter a value in seconds for the poll interval. This causes the
page to re-read the statistics from the router and refresh the page
automatically. To modify the poll interval, click the S
Stop
button and then click
Start
to restart automatic refresh.
Viewing the IPsec Connection Status
This page displays the status of IPSec connections. You can change the status of a
connection to either establish or disconnect the configured SAs (Security
Associations).
•
Policy Name
—The name of the IKE or VPN policy associated with this SA.
•
Endpoint
—Displays the IP address of the remote VPN gateway or client.
•
Tx KB
—The data transmitted (in KB) over this SA.
•
Tx Packets
—The number of IP packets transmitted over this SA.
•
State
—The current status of the SA for IKE policies. The status can be N
Not
Connected
or I
IPsec SA Established.