User's Manual

Introduction
Viewing Device Statistics
Cisco RV 110W Administration Guide 24
1
•
Connection Type
—Indicates if the WAN IPv4 address is obtained
dynamically through a DHCP server, assigned statically by the user, or
obtained through a PPPoE/PPTP/L2TP ISP connection.
•
Connection State
—Indicates if the WAN port is connected to the Internet
Service Provider.
•
IP Address
—IP address of the WAN port.
•
Subnet Mask
—Subnet Mask for the WAN port.
•
NAT
—Indicates if the security appliance is in NAT mode (enabled) or routing
mode (disabled).
•
Gateway
—Gateway IP address of the WAN port.
•
Primary DNS
—Primary DNS server IP address of the WAN port.
•
Secondary DNS
—Secondary DNS server IP address of the WAN port.
•
NAT (IPv4 Only Mode)
—Indicates if the security appliance is in NAT mode
(enabled) or routing mode (disabled).
If connection is DHCP Enabled:
•
DHCP Server
—Indicates the IP address of the DHCP server to which WAN
port is connected.
•
Lease Obtained
—Indicates the time at which lease is obtained from the
DHCP server.
•
Lease Duration
—Indicates the duration for which the lease would remain
active.
Click R
Renew
to release the current IP address and obtain a new one, or R
Release
to
release the current IP address only.
Wireless Information
This section displays information about the Wireless Radio settings.
•
Country
—Displays the country for which the radio is configured.
•
Operating Frequency
—Displays the operational frequency band.
•
Wireless Network Mode
—Displays the Wi-Fi™ mode of the radio (for
example, N or N/G,).
•
Channel
—Displays the current channel in use by the radio.