User's Manual

Administering Your Cisco RV 120W
Configuring Logging
Cisco RV 120W Administration Guide 133
7
Other Event Logs
Select the type of event to be logged. The following events can be recorded:
•
Source MAC Filter
—Check this box to log packets matched due to source
MAC filtering. Uncheck this box to disable source MAC filtering logs.
•
Bandwidth Limit
—Check this box to log packets dropped due to Bandwidth
Limiting.
Configuring Remote Logging
Log Options
In the R
Remote Log Identifier
field, enter a prefix to add to every logged message
for easier identification of the source of the message. The log identifier will be
added to both e-mail and Syslog messages.
Enable E-Mail Logs
This section is used to configure e-mail settings for sending logs. It contains the
following fields:
•
E-Mail Logs
—Disabled by default. Select the check box to enable e-mail
logs.
•
E-mail Server Address
—Enter the IP address or Internet Name of an SMTP
server. The router will connect to this server to send e-mail logs when
required.
•
SMTP Port
—Configure the port to connect smtp server.
•
Return E-mail Address
—Enter the e-mail address where the replies from
the SMTP server are to be sent (required for failure messages).
•
Send To E-mail Address(1)
—Enter the e-mail address where the logs and
alerts are to be sent.
•
Send To E-mail Address(2)
—Enter the e-mail address where the logs and
alerts are to be sent.
•
Send To E-mail Address(3)
—Enter the e-mail address where the logs and
alerts are to be sent.
•
Authentication with SMTP server
—If the SMTP server requires
authentication before accepting connections, select either L
Login Plain
or
CRAM-MD5
and enter the Username and Password to be used for
authentication. To disable authentication, select N
None
.