User's Manual

Configuring Virtual Private Networks (VPNs) and Security
Configuring VPNs
Cisco RV 120W Administration Guide 114
5
The Active IPsec SAs table displays a list of active IPsec SAs. Table fields are as
follows:
Configuring IPsec Users
The configured IPsec users (both XAUTH and QuickVPN) are listed in the List of
Users viewed by choosing V
VPN
> I
IPsec
> I
IPsec Users
. The VPN gateway
authenticates users in this list when XAUTH is used in an IKE policy. QuickVPN
client can access only default LAN hosts.
To add new users:
STEP 1 Click A
Add
.
STEP 2 Enter the user name, or the unique identifier for the XAUTH user.
STEP 3 In the U
User Type
field, select the type of the Remote Peer: Standard IPsec (XAuth),
or Cisco QuickVPN.
STEP 4 If you chose Q
QuickVPN
, you can check the A
Allow User to Change Password
box to
allow the QuickVPN user to change their password. Uncheck if you would like to
maintain the password for them.
STEP 5 Enter the alphanumeric password for this user
STEP 6 Enter the password again to confirm.
STEP 7 Click S
Save
.
.
Field Description
Endpoint IP address of the remote VPN gateway or client.
Policy Name IKE or VPN policy associated with this SA.
State Status of the SA for IKE policies: Not Connected or
IPsec SA Established.
Tx (KB) Kilobytes of data transmitted over this SA.
Tx (Packets) Number of IP packets transmitted over this SA.