User's Manual

Configuring Virtual Private Networks (VPNs) and Security
Configuring VPNs
Cisco RV 120W Administration Guide 103
5
To quickly set up a VPN tunnel using VPN Wizard:
STEP 1 Choose I
IPsec
> V
VPN Wizard
.
STEP 2 Set the C
Connection Name
and P
Pre-Shared
key. The connection name is used for
management, and the pre-shared key will be required on the VPN client or
gateway to establish the tunnel.
STEP 3 Choose the Remote Gateway Type (I
IP Address
or F
Fully-Qualified Domain Name
).
STEP 4 Enter the Remote WAN IP Address/Internet Name.
STEP 5 Choose the Local Gateway Type (I
IP Address
or F
Fully-Qualified Domain Name
).
STEP 6 Enter the Local WAN IP Address/Internet Name. This field can be left blank if you
are not using a different FQDN or IP address than the one specified in the WAN
port configuration.
STEP 7 Configure the LAN accessibility details in the Secure Connection Remote
Accessibility section:
• Remote LAN IP address
• Remote LAN Subnet Mask
NOTE The IP address range used on the remote LAN must be different from the IP
address range used on the local LAN.
STEP 8 Click S
Save
.
STEP 9 The Wizard creates a corresponding IKE policy with the following default values
(these can be accessed from a link on the Wizard page):