User's Manual

1216264_002
Exede Residential Satellite Modem RM5110 Series Page 4
Ensure that the Satellite Modem at all times has at least three inches of clearance from other
objects on each side and that air can flow freely to the Satellite Modem.
Do not place anything on top of the Satellite Modem.
Keep the Satellite Modem out of the reach of children and pets.
Keep the Satellite Modem upright at all times and firmly secured in the provided stand.
Do not place the Satellite Modem on its side or allow it to rest on its side.
Cautions - A CAUTION is defined as a procedure or practice that, if not correctly followed, could result in
equipment damage or destruction. Always observe the following CAUTIONS:
To ensure regulatory and safety compliance, only use the provided power and interface cables.
Do not open the unit. Do not perform any servicing other than that contained in the installation
and troubleshooting instructions. Refer all servicing to qualified service professional.
Avoid damaging the Satellite Modem with static by first touching the coaxial cable connector
when it is attached to the earth grounded coaxial cable wall outlet. Always first touch the
coaxial cable connector on the Satellite Modem when you are disconnecting or re-connecting
your Ethernet cable from the Satellite Modem or your computer.
Only wipe the Satellite Modem with a clean, dry cloth. To avoid equipment damage, never use
cleaning fluids or similar chemicals. Do not spray cleaners directly on the Satellite Modem or use
forced air to remove dust.
Do not paint or place decals on the Satellite Modem housing.
Install an AC surge arrestor in the AC outlet to which the Satellite Modem is connected. This is to
avoid damaging the equipment by local lightning strikes and other electrical surges.
The power adapter supplied with the Satellite Modem shall be used only with the Satellite
Modem. Do not use the Satellite Modem power adapter with any other equipment, including
other modems.
Do not use any other power adapter with the Satellite Modem other than the one supplied with
it.
Notices
The Satellite Modem was qualified under test conditions that included the use of the supplied
cable between system components. To be in compliance with regulations, the installer, or user,
must use this cable and install it properly.
Different types of cord sets may be used for connections to the main supply circuit. Use only a
main line cord that complies with all applicable product safety requirements of the country of
use.
Installation of the Satellite Modem must be in accordance with national wiring codes.
ViaSat hereby declares that the Satellite Modem is in compliance with the essential
requirements and other relevant provisions of Directive 1999/5/EC.