User`s manual

MXGG Series CyberResearch

Motherboards

Figure 4-19: LAN Connection

Step 3: Insert the LAN cable RJ-45 connector. Once aligned, gently insert the LAN

cable RJ-45 connector into the on-board RJ-45 connector. Step 0:

4.6.4 Parallel Device Connection

The MXGG has a single female DB-25 connector on the external peripheral interface

panel for parallel devices. Follow the steps below to connect a parallel device to the

MXGG.

Step 1: Locate the DB-25 connector. The location of the DB-25 connector is shown in

Chapter 3.

Step 2: Insert the DB-25 connector. Insert the DB-25 connector of a parallel device

into the DB-25 connector on the external peripheral interface. See

Figure 4-20.