User`s manual

MXGD Series CyberResearch

Motherboards

Step 2:

WARNING:

If the USB pins are not properly aligned, the USB device can burn out.

Step 3: Align the connectors. Each cable has two connectors. Correctly align pin 1on

each cable connector with pin 1 on the MXGD USB connectors.

Step 4: Insert the cable connectors.. Once the cable connectors are properly aligned

with the USB connectors on the MXGD, connect the cable connectors to the

onboard connectors. See Figure 5-17.

Figure 5-18: Four Port USB Cable Connection

Step 5: Attach the bracket to the chassis. The USB 2.0 connectors are attached to a

bracket. To secure the bracket to the chassis please refer to the installation

instructions that came with the chassis.Step 0:

5.8 External Peripheral Interface Connection