User`s manual

MXGD Series CyberResearch

Motherboards

of the cable to the connector at the back of the SATA drive. See Figure 5-16.

Step 4: Connect the SATA power cable. Connect the SATA power connector to the

back of the SATA drive. See Figure 5-16. Step 0:

Figure 5-16: SATA Power Drive Connection

5.7.6 USB Cable (Dual Port)

The MXGD is shipped with a dual port USB 2.0 cable. To connect the USB cable

connector, please follow the steps below.

Step 1: Locate the connectors. The locations of the USB connectors are shown in

Chapter 3.

WARNING:

If the USB pins are not properly aligned, the USB device can burn out.

Step 2: Align the connectors. The cable has two connectors. Correctly align pin 1 on

each cable connector with pin 1 on the MXGD USB connector.

Step 3: Insert the cable connectors. Once the cable connectors are properly aligned