User`s manual

CyberResearch
®
Motherboards MXGD Series
CyberResearch, Inc. 97
25 Business Park Drive P: [phone]; F: [phone]
Branford, CT USA www.cyberresearch.com
5.7.3 Single RS-232 Cable with Slot Bracket
The single RS-232 cable consists of one serial port connectors attached to a serial
communications cable that is then attached to a D-sub 9 male connector that is mounted
onto a bracket. To install the single RS-232 cable, please follow the steps below.
Step 1: Locate the connector. The location of the RS-232 connector is shown in
Chapter 3.
Step 2: Insert the cable connector. Insert the connector into the serial port box header.
See Figure 5-13. A key on the front of the cable connectors ensures the
connector can only be installed in one direction.
Figure 5-13: Single RS-232 Cable Installation
Step 3: Secure the bracket. The single RS-232 connector has one D-sub 9 male
connector secured to a bracket. To secure the bracket to the chassis please
refer to the reference material that came with the chassisStep 0: