User`s manual

MXGD Series CyberResearch

Motherboards

5.7.2 Dual RS-232 Cable with Slot Bracket

The dual RS-232 cable slot connector consists of two connectors attached to two

independent cables. Each cable is then attached to a D-sub 9 male connector that is

mounted onto a slot. To install the dual RS-232 cable, please follow the steps below.

Step 1: Locate the connectors. The locations of the RS-232 connectors are shown in

Chap

ter 3.

Step 2: Insert the cable connectors. Insert one connector into each serial port box

head

ers. See Figure 5-12. A key on the front of the cable connectors ensures

the connector can only be installed in one direction.

Figure 5-12: Dual RS-232 Cable Installation

Step 3: Secure the bracket. The dual RS-232 connector has two D-sub 9 male

con

nectors secured on a bracket. To secure the bracket to the chassis please

refer to the reference material that came with the chassisStep 0: