User`s manual

CyberResearch
®
Motherboards MXGD Series
CyberResearch, Inc. 91
25 Business Park Drive P: [phone]; F: [phone]
Branford, CT USA www.cyberresearch.com
5.5.1 Clear CMOS Jumper
Jumper Label:
JP2
Jumper Type:
2-pin header
Jumper Settings:
See Table 5-2
Jumper Location:
See Figure 5-9
If the MXGD fails to boot due to improper BIOS settings, the clear CMOS jumper clears
the CMOS data and resets the system BIOS information. To do this, use the jumper cap to
close pins 1 and 2 for a few seconds then remove the jumper cap and enable pins 1 and 2
to remain open.
If the “CMOS Settings Wrong” message is displayed during the boot up process, the fault
may be corrected by pressing the F1 to enter the CMOS Setup menu. Do one of the
following:
 Enter the correct CMOS setting
 Load Optimal Defaults
 Load Failsafe Defaults.
After having done one of the above, save the changes and exit the CMOS Setup menu.
The clear CMOS jumper settings are shown in Table 5-2.
Jumper Select Description
Open Keep CMOS Setup Default
Short Clear CMOS Setup
Table 5-2: Clear CMOS Jumper Settings
The location of the clear CMOS jumper is shown in Figure 5-9 below.