User`s manual

Gasket Replacement
A gasket used for a long time may gradually lose its ability to protect the LCD from fluids and
vapors. Scratches or dirt may accumulate and it is recommended to change the gasket at least
once a year.
Replacement Procedure:
Step 1. Place the LCD on a flat, level surface with the display screen facing downwards. If
the LCD is mounted on a vertical wall or panel, remove it from the installation site.
Step 2. Remove the old gasket from the sides of the LCD.
Step 3. Attach the new gasket to the LCD. Make sure the gasket fits precisely into the
groove along the rear-side edges of the LCD’s front panel.
Step 4. Check if the gasket is properly attached to the LCD.
NOTE:
The compliance to the IP 65 standard depends on correct installation of the
gasket. Be sure to check for proper installation of the gasket before
installing it into previous position.
CyberResearch
®
Displays MPD 1xAG Series
CyberResearch, Inc. 59
25 Business Park Drive P: [phone]; F: [phone]
Branford, CT USA www.cyberresearch.com