User`s manual

Steps 3 & 4. Fasten the LCD along with the rack-mount kit to the rack posts of a rack
cabinet.
Figure 2
2-12: Rack-mounting Steps 3 and 4
2.7 Cabling
Power Supply Terminals
Connect the power cable according to the following procedures.
Step 1. Check if the power cord is disconnected from the wall plug.
Step 2. Loosen screws from the terminal, align and insert the wire terminals form your power
cord and tighten the screws. Replace the terminal block’s plastic cover (if applied).
Cable Tie Attachment
After all cables have been properly connected, you may use cable ties to secure these cables to
the plastic cable tie holders on the rear panel. Doing this helps prevent accidental
disconnection which might lead to system down time.
CAUTION!
Following are the responsibilities of system design and integrators:
1. Separation of the input/output lines to increase noise resistance.
Methods like twistin
g the power wires attached to the terminal should
CyberResearch
®
Displays MPD 1xAG Series
CyberResearch, Inc. 37
25 Business Park Drive P: [phone]; F: [phone]
Branford, CT USA www.cyberresearch.com