User`s manual

MMGA Series CyberResearch

Motherboards

The MMGA is shipped with a dual port USB 2.0 cable. To connect the USB cable

connector, please follow the steps below.

Step 1: Locate the connectors. The locations of the USB connectors are shown in

Chapter 3.

WARNING:

If the USB pins are not properly aligned, the USB device can burn out.

Step 2: Align the connectors. The cable has two connectors. Correctly align pin 1on

each cable connector with pin 1 on the MMGA USB connector.

Step 3: Insert the cable connectors. Once the cable connectors are properly aligned

with the USB connectors on the MMGA, connect the cable connectors to the

onboard connectors. See Figure 1-59.

Figure 1-59: Dual USB Cable Connection

Step 4: Attach the bracket to the chassis. The USB 2.0 connectors are attached to a

bracket. To secure the bracket to the chassis please refer to the installation