User`s manual

MMGA Series CyberResearch

Motherboards

Figure 1-56: Dual RS-232 Cable Installation

Step 3: Secure the bracket. The dual RS-232 connector has two D-sub 9 male

connectors secured on a bracket. To secure the bracket to the chassis please

refer to the reference material that came with the chassisStep 0:

5.7.3 SATA Drive Connection

The MMGA is shipped with two SATA drive cables and one SATA drive power cable. To

connect the SATA drives to the connectors, please follow the steps below.

Step 1: Locate the connectors. The locations of the SATA drive connectors are shown

in Chapter 3.

Step 2: Insert the cable connector. Press the clip on the connector at the end of the

SATA cable and insert the cable connector into the onboard SATA drive

connector. See Figure 1-57.