User`s manual

MMGA Series CyberResearch

Motherboards

holes. (See Figure 1-50)

Figure 1-50: Securing the Heat sink to the PCB Board

Step 5: Tighten the screws. Use a screwdriver to tighten the four screws. Tighten each

nut a few turns at a time and do not over-tighten the screws.

Step 6: Connect the fan cable. Connect the cooling kit fan cable to the fan connector

on the MMGA. Carefully route the cable and avoid heat generating chips and fan

blades. Step 0:

5.4.3 DIMM Installation

WARNING:

Using incorrectly specified DIMM may cause permanently damage the

MMGA. Please make sure the purchased DIMM complies with the

memory specifications of the MMGA. DIMM specifications compliant

with the MMGA are listed in Chapter 2.