User`s manual

CZGG LU-10-X Series CyberResearch
®
CPU Cards
80 ©Copyright 2007 CyberResearch, Inc.

25 seconds
 30 seconds
 35 seconds
The best setting to use if the onboard IDE controllers are set to a specific IDE disk drive in
the AMIBIOS is “0 seconds” and a large majority of ultra ATA hard disk drives can be
detected well within “5 seconds.”
 ATA (PI) 80Pin Cable Detection [Host]
When an Ultra ATA/66, an Ultra ATA/100 or an Ultra ATA/133 IDE hard disk drive is used,
an 80-conductor ATA cable must be used. The 80-conductor ATA cable is plug compatible
with the standard 40-conductor ATA cable. The system must detect the presence of
correct cable so that the AMI BIOS can instruct the drive to run at the correct speed for the
cable type detected.
The ATA (PI) 80Pin Cable Detection BIOS option determines how the IDE cable is
detected.

Host & Device
(Default) Both the CPU Card onboard IDE controller and IDE
disk drive are used to detect the type of IDE cable
used.

Host
The CPU Card onboard IDE controller detects the
type of IDE cable used.

Device
The IDE disk drive detects the IDE cable type.
5.4.2.1 IDE Master, IDE Slave
IDE Master and IDE Slave configuration options for both primary and secondary IDE
devices are shown in the BIOS menu below.