User`s manual

CZGG LU-10-X Series CyberResearch

CPU Cards

4.3.5 Peripheral Device Connection

Cables provided by CyberResearch that connect peripheral devices to the board are listed

in Table 4-1. Cables not included in the kit must be separately purchased.

Quantity Type

1 mini jumper pack

1 ATA33 HDD cable

1 Power cable

1 RS-232 cable

Table 4-1: Cables Provided by CyberResearch

4.3.5.1 IDE Disk Drive Connector (IDE1)

The cable used to connect the CZGG LU-10-X to the IDE HDD is a standard 44-pin

ATA33 flat cable. To connect an IDE device to the CZGG LU-10-X follow the instructions

below.

Step 7: Find the ATA33 flat cable in the kit that came with the CZGG LU-10-X.

Step 8: Connect one end of the cable to the IDE1 connector on the CZGG LU-10-X. A

keyed pin on the IDE connectors prevents it from being connected incorrectly.

Step 9: Locate the red wire on the other side of the cable that corresponds to the pin 1

connector.

Step 10: Connect the other side of the cable to the IDE device making sure that the pin 1

cable corresponds to pin 1 on the connector.Step 0:

NOTE:

When two EIDE disk drives are connected together, back-end jumpers on

the drives must be used to configure one drive as a master and the other as

a slave.