User`s manual

CZGG LU-10-X Series CyberResearch
®
CPU Cards
54 ©Copyright 2007 CyberResearch, Inc.
3.4 Onboard Jumpers
NOTE:
A jumper is a metal bridge that is used to
close an electrical circuit. It consists of
two metal pins and a small metal clip
(often protected by a plastic cover) that
slides over the pins to connect them.
To CLOSE/SHORT a jumper means
connecting the pins of the jumper with
the plastic clip and to OPEN a jumper
means removing the plastic clip from a
jumper.
The CZGG LU-10-X CPU card and daughter expansion board have nine onboard
jumpers, two on the CPU card and six on the expansion daughterboard. The jumpers are
described in Table 3-29.
Description Label Type Location
Clear CMOS J4 3-pin header CZGG LU-10-X
LCD voltage setup JP1 6-pin header CZGG LU-10-X
CF card setup JP2 3-pin header CZGG LU-10-X
LVDS Setting JP3 4-pin header LCDC
LVDS-LUKE-A
Table 3-29: Jumpers
3.4.1 LVDS Panel Voltage Selection Jumper
WARNING:
Making the wrong setting on this jumper may cause irreparable damage to
both the CPU card and the LCD screen connected to the onboard
connector.
Figure: Jumper