User`s manual

CYRAQ 17A Series CyberResearch

Displays

NOTE: If the screen remains blank or displays the error message “Out of

Range” or “No Input Signal,” there may be a connection or signal

problem. One or a combination of the possibilities listed below may be

the cause:

¾ Windows resolution is set either too high or two low for the display;

check the resolution by reinstalling the old monitor

¾ The refresh rate may be set too high. The refresh rate of an LCD

monitor doesn’t need to be set as high as a CRTs refresh rate; set the

refresh rate @ 60Hz.

¾ The power source isn’t connected correctly.

¾ The video cables aren’t tightly connected at one or both ends;

reconnect and tighten the cable adapter screws.

¾ The display is reading an input without a connected source; push Input

Select button to access the correct input.

¾ The unit is malfunctioning.