User`s manual

CyberResearch
®
Displays CYRAQ
®
21
CyberResearch, Inc. 23
25 Business Park Drive P: [phone]; F: [phone]
Branford, CT USA www.cyberresearch.com
2.6 Connecting the Display
IMPORTANT! Before connecting the power cable to the display, connect all the other
cables.
Figure 18: CYRAQ 21C Connection Layout
3 NOTE: Turn off the computer before connecting the display
1. After connecting all other cables, connect the power cable to the power jack on
the back of the display; refer to Figure 18.
2. Press the On/Off Button, the status light will illuminate.
3. Start the computer.
4. If the computer is running, restart.
5. The display should now function normally.
3 NOTE: See Section 4 Touchscreen for connection and driver instruction
3 NOTE: If the CYRAQ’s screen remains blank or displays the error message
“Out of Range” or “No Input Signal,” there may be a connection or
signal problem. One, or a combination of the possibilities listed below
may be the cause:
¾ Windows resolution is set either too high, or too low for the display;
check the resolution by reinstalling the old monitor
Powe
r
Jack
DVI Video
Por
t
Analog
Video Port
S-Video
Composite
Video