User`s manual

CYRAQ

21 CyberResearch

Displays

4.2.4 Calibration Test

This is the last screen displayed in the calibration process.

1. Touch the screen and notice if the calibration target is displayed under your finger

or stylus. If the target appears directly under your finger, select the “Accept”

button.

2. If the target does not appear directly beneath your finger or stylus, select the

“Cancel” button, reconfigure your calibration options and recalibrate until you get

an acceptable calibration. You may adjust the “Offset”, or try a different

calibration scheme.

3. Select “Accept” to apply and record your calibration data.

4. Select “Cancel” to return to the calibration tab. Once you return to the calibration

tab, select, “OK” or “Apply” to save your settings.

5. If you have multiple monitors return to the “Screen Selection” tab and select

another monitor to calibrate.

Figure 27: Calibration Target